X-Coat™ Nano HS

• Application:

• Strip floors using Xlerate™ Stripper(2917FX) following all package instructions to remove old waxes, sealer and finishes.
• Rinse thoroughly and let dry.
• With clean equipment apply thin, even coats of finish.
• Allow to dry for 15-20 minutes under normal condition (50% humidity and 70°F) between coats.

• Maintenance:

• Daily: Sweep or dust mop as necessary to remove gritty soil.
• Dirty Floors: Clean with Neutral Cleaner Plus(2746FC), Blue Concentrate(2085FC) or Blue Concentrate SC(4085FC). Follow package directions for proper dilution rates. Rinse and let dry.
• Traffic Area: Clean with Blue Concentrate. Follow package directions for best results. Rinse and let dry. Apply additional thin coats of floor finish to traffic lanes as needed.
• Buffing: If desired, periodic burnishing with blended hair pads will enhance appearance.
• Periodic Complete Maintenance: When stripping is required, use Xlerate(2917FX) following label directions for best results.

• See label directions and SDS for complete usage and safety instructions.

• For best results, apply a maximum of 4 coats in 24 hours.

• X-Coat Nano is very easy to apply with a standard finish mop and dries perfectly clear.
• For best results, apply four coats the first night, then follow-up a few days later with four more coats. This gives you the desired film thickness from which to properly maintain your floor.

• High Solids formula offers greater protection with fewer coats.
• Ideal for limited maintenance programs, yet responds to daily burnishing, if desired.
• Low-emissions formula – meets California’s new 1% VOC Regulation.
• Coverage – up to 3,000 square feet.
• Fast-drying – 15-20 minutes under normal conditions (50% humidity and 70°F) between coats.
• Slip-resistant – UL Classified.

                         Propane                    Battery                  Electric(1000+rpm)